Recent Posts

Pages: [1] 2 3 ... 10
1
Builds / Re: JYD's new rig build
« Last post by RCinLaveen on Yesterday at 08:20:32 AM »
Looking good
2
Builds / Re: JYD's new rig build
« Last post by ROCKZILLA on March 14, 2019, 03:39:36 PM »
 Y’all are doing a fine job, now I just put some speed on that!
3
Builds / Re: JYD's new rig build
« Last post by JYD on March 14, 2019, 11:52:59 AM »




4
Trail Pics & Vids / Re: Possible Trail
« Last post by ROCKZILLA on March 08, 2019, 11:19:57 AM »
 I want to drive over there in my truck and walk it one more time, then we will figure out when they hit it
.
5
Trail Pics & Vids / Re: Possible Trail
« Last post by JYD on March 07, 2019, 08:46:16 PM »
I am in
6
Trail Pics & Vids / Mammoth
« Last post by ROCKZILLA on March 07, 2019, 08:56:47 AM »
A few of us hit Mammoth last weekend. All I have to say is if you have never been to Mammoth go, but be ready to push your rig way beyond what your comfortable pushing it! Here are a few pictures
7
Trail Pics & Vids / Re: Possible Trail
« Last post by ROCKZILLA on March 07, 2019, 08:53:53 AM »
I have been thinking about this area for a month now. Who's ready to go give it a shot with me?
8
Builds / Re: Big Little Buggy Build
« Last post by ROCKZILLA on March 07, 2019, 08:50:04 AM »
I found a large bolder that knocked a hole in my oil pan while in Mammoth. I have never liked how far the pan stuck down, but now I had to change it. I bought a Speedway LS swap shallow pan and got it installed and it is almost three inches shallower than the stock van pan I had. Now I need to quit being lazy and build the belly pan I have the material to do anyway. I also swapped out the 2"x16" rear shocks for 2.5"x16" and it sits much better and handles the weight of my kids better also.
9
Builds / Re: Durf's Bronco
« Last post by ZJ Guy on March 04, 2019, 05:55:48 PM »
Been along time folks. I've just been so busy with work and life, haven't really had any free time. In the last year or so since I've logged on, I made some minor but important progress. Got 3 new power window motors in and working. Lift gate had a bad latch safety override switch I had to bypass to get working. Got all new window moldings and seals to keep cockpit dry. Replaced just about every gasket and seal on the motor so no more leaks. And the most important step of all - fixed the slippin transmission. Bought a Performance Automatic stage 1 valve body and deep sump cooling fin trans pan, adjusted the shift linkage on the tranny side while valve body was out. Drives like a dream now. Transmission is almost smooth enough to earn the ultimate compliment any tranny can get, that it shifts like a Turbo Hydromatic lol.
10
Builds / Re: The Beast 2.0?
« Last post by kkattfish on February 28, 2019, 06:06:59 PM »
It is almost boating season and the fishing should be good here real soon.
I'm working on my boat this weekend also. 
Pages: [1] 2 3 ... 10

SimplePortal 2.3.3 © 2008-2010, SimplePortal